What the Springville code says
Springville's municipal code, section 4-13-328, requires that a sump be city approved. Section 4-13-202(2)(h) says foundation or footing drains, and crawl space or basement pump discharges, are allowed only if the city approves them in writing. The Building Division at 801-489-2704 can tell you what documentation applies to your address.
The practical lesson is simple: decide where the water will go before you buy a pump. An approved route matters more than the pump brand.
What a discharge line does
The pump lifts water out of the pit and pushes it through a pipe to a place where it can safely go. A check valve in the line stops water from falling back into the pit when the pump shuts off. The pipe runs up through the basement wall or rim joist and out to the yard.
If the line is too short, it can drop water beside the foundation, where it soaks back in and returns to the pit. If it is blocked or frozen, the pit fills and the basement floods.
How to route a discharge line
Good routing prevents most callbacks.
Choose an approved outlet
Confirm with the city where discharge is allowed. Do not assume a street, a neighbor's yard or a sanitary sewer is acceptable.
Keep it away from the foundation
Run the end of the line well away from the house, with the ground sloping away so water does not return.
Add a check valve
Install it on the vertical run above the pump so water does not drain back.
Slope the pipe
Pitch the exterior section so the pipe drains after the pump stops.
Need a discharge line checked?
Call (385) 488-1892 and we will look at your pit and your routing.
Common discharge problems
Most failures are simple.
| Problem | Cause | Fix |
|---|---|---|
| Pump runs constantly | Water recirculating from a short line | Extend the outlet away from the house |
| Pump runs but pit stays full | Blocked or frozen discharge | Clear the line and add a cold weather outlet |
| Banging sound at shutoff | Water hammer from a check valve | Replace or reposition the valve |
| Ice at the outlet | Water freezing at the end of the line | Extend or add a pop up outlet |
Winter and spring in Springville
Springville's January mean low is about 22 degrees Fahrenheit, and the city noted high spring flows in Hobble Creek in 2023 from heavy snowmelt. Those two facts shape sump behavior: a pump that stays idle in a dry fall must work hard in April.
In winter, ice can block the outlet of a buried or surface discharge line. A line that ends in an open pipe at ground level can freeze shut. Ask about options such as a longer run, a larger outlet or a freeze relief outlet that opens if the main outlet ices over. Check the outlet after the first deep freeze and again before spring thaw.
Sizing and pipe choice
Most residential discharge lines use rigid PVC or flexible corrugated pipe. Rigid pipe holds a slope better and does not sag where water can pool and freeze. Use the same size as the pump outlet or larger. A smaller pipe slows flow and makes the pump work harder.
Keep the number of elbows low. Every sharp turn adds resistance. A union or a rubber coupling near the pump makes service easier, because the pump must come out of the pit for cleaning or replacement. Use a check valve that is easy to reach and mark which way water should flow.
Test the system every season
Pour a few gallons of water into the pit until the float lifts and the pump starts. Watch that water leaves the outlet and does not return. Check that the pump shuts off cleanly and the check valve does not bang. Do the test in early spring before snowmelt and again in fall.
Look at the pit for debris, gravel or mud that can jam the float. A float that sticks against the wall of a narrow pit is a common cause of failure. Clean the pit and make sure the pump sits on a flat base rather than in sediment.
Do not tie it to the sewer
Sump water should not enter the sanitary sewer line. It can overload the system and is generally prohibited. If your basement has a toilet or a shower below the sewer level, you may need a sewage ejector, a different machine. See sump pump service for pumps and the difference between the two.
Backup power and alarms
Storms that fill pits often also cut power. A battery backup pump or a water powered backup keeps the pit from overflowing during an outage. A high water alarm gives you early warning if the main pump fails. Neither replaces a well routed discharge, but both buy time when something goes wrong.
If your basement is finished, ask how much water the pit holds before overflowing and how long the backup runs on a charge. Replace backup batteries on the maker schedule. Test the alarm when you test the pump.
Where it flows in nearby towns
Rules in Mapleton and Spanish Fork are set by those cities. Call their offices before you route a discharge. Do not assume Springville rules apply elsewhere.
Hobble Creek and debris
The city reminds owners that creek channels can clog with debris and that debris on your bank is your responsibility. Sending discharge toward a clogged channel can backfire. Keep your section of bank clear and ask the city before connecting to any channel.
Code and permit note
The International Plumbing Code (IPC) is the baseline, but Springville code sections 4-13-328 and 4-13-202 decide where a sump may discharge.
Common questions
Only with city approval. The code says sump discharges must be approved, so call the Building Division at 801-489-2704.
Far enough that water does not flow back toward the foundation. We look at your slope and soil on a visit.
A short discharge, a stuck float or very high groundwater can cause it. We diagnose each.
If a power outage during a storm would flood your basement, a backup is worth considering.
No. Sump water should not go into the sanitary sewer. Ask the city for an approved route.
