What the city report does and does not say
The 2024 report lists total dissolved solids from 240 to 476 ppm across the system's sources and does not report hardness, calcium or magnesium. It also lists sodium detected between 2.6 and 38 ppm. Total dissolved solids is not hardness, and individual homes can differ depending on the source they receive.
The practical step is to test. A hardness kit from a store gives a number in grains per gallon or parts per million in minutes. You can also call the Water Division at 801-489-2740 to ask how the water is sourced for your street.
Signs of hard water
These are common symptoms. None proves hardness without a test.
White crust on fixtures
Scale on faucets, showerheads and glass is mineral buildup.
Spots on dishes
Cloudy glassware after the dishwasher can come from minerals.
Dry skin and stiff laundry
Soap reacts with minerals and leaves residue.
Short water heater life
Scale on the tank floor and elements shortens appliance life.
Softener, filter or both
They solve different problems.
| System | Removes or reduces | Does not address |
|---|---|---|
| Salt based softener | Hardness minerals (calcium, magnesium) | Chlorine taste, most chemicals |
| Carbon filter | Chlorine taste and odor, some organics | Hardness |
| Sediment filter | Sand, silt, rust particles | Dissolved minerals |
| Reverse osmosis at one tap | Many dissolved solids at the drinking tap | Whole house hardness |
Not sure what your water needs?
Call (385) 488-1892. We will tell you how to test and what the numbers mean.
How an installation works
A softener needs water, a drain and power.
Test and size
We use your test result and household size to size the unit.
Place and plumb
We install on the main with a bypass, a drain line and an air gap for the brine line.
Set and program
We set hardness and regeneration, and fill the brine tank.
Show and explain
We explain salt use, bypass operation and maintenance.
What affects the cost
Prices depend on the system and the home.
Call (385) 488-1892 for your price.
Maintaining a softener
A salt based softener needs salt in the brine tank, and the level should be checked every month or two. A salt bridge, a hard crust over the salt, stops the unit from making brine, so a quick poke with a broom handle now and then prevents hard water from returning.
Resin beads wear over many years, and control valves fail like any mechanical part. If hard water returns, check the bypass is not open, the salt is not bridged and the settings still match your water test, then call us.
Lead and flushing: a note from the city report
Springville's report covers lead in home plumbing and recommends flushing taps for 30 seconds to 2 minutes when water has sat for hours before using it for drinking or cooking. It also suggests a filter certified by an ANSI accredited certifier if you want to reduce lead, and the city can discuss testing at 801-489-2740.
Softening does not remove lead, so ask which certification a filter holds. For plumbing that feeds the system, see plumbing installation and our water heater repair page for scale related problems.
Code and permit note
Code note: a softener drain needs an air gap under International Plumbing Code (IPC) principles so waste water cannot flow back into the system.
Common questions
The city report does not list a hardness number. Test your tap with a kit or ask the Water Division at 801-489-2740, because the answer can vary by source.
Softened water has a small sodium increase, but most people do not notice it. A separate filter can improve taste.
No. If your test shows soft water, skip it and save the money.
Yes. We service control valves, resin tanks and brine systems.
Yes. We dispatch to Mapleton, Spanish Fork, Salem and Provo.
